Categories
Linux

menuconfig vs. gconfig

I don’t recommend using make gconfig to create a linux kernel config file. So far I have attempted to use the interface twice and both times I failed to enable some important options. This doesn’t happen when I configure using menuconfig. I think my eyes cross while using the GUI interface and I end up rebooting with no support for my wireless net. :( (O’ Noes! I killed it.)

Categories
Linux

kismet signal levels

kismet signal powerkismet card powerKernel 2.6.20 introduced a nice update for the ipw2200 driver. Previously the driver didn’t report power levels for wireless networks. This would show up when sniffing with Kismet, while viewing detailed info about a network. Using the signal levels it’s possible to home-in on the access point’s location. Sitting inside my house my connection with the home wap is about 44 decibels and the worst reading has been about 80 while sniffing distant networks. The signal reading also gives a clear indication whether it’s to worth it to attempt to connect.

Kernel config

CONFIG_IPW2200=m
CONFIG_IPW2200_MONITOR=y
CONFIG_IPW2200_RADIOTAP=y
CONFIG_IPW2200_PROMISCUOUS=y
# CONFIG_IPW2200_QOS is not set
# CONFIG_IPW2200_DEBUG is not set

Categories
Linux

documenting…

Documentation is often the most neglected part of a project because it’s easy to “just to do it” and jump to the next thing. It’ll come back to bite me though if I ever had to restore the laptop from scratch. So far I’ve got a seed started on describing the config of my laptop. I’m trying not to duplicate info found elsewhere. I’d rather link to more extensive documentation and use this page to document changes specific to my laptop.

I’d also like to say the auto-thumbnailing function when I upload a image to WordPress is wonderful. I’m used to doing manually. I wish I switched from blogger a long time ago.

Categories
everything else Linux

I am alive

New wordpress blog installed. This website has been dead for a year or more and I finally decided to start using it again. After all, I was paying for it to be idle. To prevent this website from going dead again using it for something useful might help. The previous blogger blog was only a place for rants and little else. On WordPress I want to document problems/issues and their solutions while using Gentoo Linux, my favorite distro. With the occassional rant obviously. :) After some time, I want this website to be where I search “how did I fix that?” when the same thing happens six months later. WordPress is a nice piece of software, thanks.